E120/SeaRay Navigator Upgrade ?

[rvaupel23]

When connecting my CAM220 to the HS5 through the PoE Injector, can/should I use this connectivity method:

1. HS5 SeaTalkhs Network Switch (A80007) - Under the helm
2. RayNet to RJ45 Port Male Cable, 1M (A62360) - From the HS5 to the PoE injector
3. PoE Injector (R32141) - Under the helm where my HS5 and fuse block is located
4. G-Series Highspeed Patch Cable, 10M (E06056) - From the injector routed up/back to the camera's location
5. Supplied Waterproof RJ45 ethernet coupler (R32142) - To connect the camera's ethernet cable to the patch cable

I wasn't sure between these cables, the injector, and/or the coupler if anything was acting as a "cross-over" that might prevent connectivity. The CAM220 installation documentation doesn't describe this exact example. Thanks.