Raymarine forum / Raymarine Forums / Instruments v / wind transducer setup

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
wind transducer setup
04-19-17, 09:55 AM
Post: #16
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: wind transducer setup
Charlie,

The o-ring seal should prevent water from entering and condensation from building up inside of the masthead block's socket. Should water enter/accumulate inside of the masthead block's socket, then then it can short out the circuit board inside of the masthead. You may want to consider sending the masthead block in addition to the wind transducer to Raymarine’s Product Repair Center to be bench checked / serviced.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
wind transducer setup - charlie98117 - 01-09-17, 01:47 PM
RE: wind transducer setup - Chuck - Raymarine - Moderator - 04-19-17 09:55 AM
wind transducer setup - Marcmmm - 12-04-17, 10:56 AM

Forum Jump:


User(s) browsing this thread: 3 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication