[CA] [CA11] Fishfinder for Axiom PRO 12 RVX

[robbi.wolf]

Thanks a lot Chuck!
Really appreciate your answer!

I would like to go for RealVision 3D images.
I think the bottom in the front engine room is quite flat and I was thinking installing :
Raymarine RV-300 RealVision 3D Plastic Through Hull Transducer 0 Degree.
- is advisable to put the transducer more forward and install the Raymarine RV-312 RealVision 3D Plastic Through Hull Transducers, Port and Starboard 12 degree ???

Understood I will have to run the wire from the location to the the instrument.
- do I need a sonar module/adaptor between the transducer and the MFD?

- if I disconnect the tridata transducer I will still have the depth information in the Chart page ??

Attached is a picture of the plan of the boat
Again thank you
Roberto