Threaded Mode | Linear Mode

chrisboat

As was suggested I will be attaching the existing the Raystar 125 GPS Antenna to a connector block that will be be connected to the existing Seatalk network.

My questions:
1. Since I am guessing that the output of the Raystar 125 is NEMA 0183 is the Sea talk to NG converter actually converting Seatak to NEMA 2000 (NG)?

2. If that is true why couldn't I use that to same connector block to attach my other NEMA 0183 (DSC and AIS) to convert my data to NEMA 2000 (NG) instead of using an Actisense.

One possibility could be there may be a data speed conflict 4800 for GPS and Seatalk versus 38400 for DCS and AIS and MEMA 2000 (NG). Or it may be something else I am not aware of.

I may have this all wrong. But I thought I would ask.

Update: while looking at my diagram posted in my earlier post I see that there is an error in the connection of the Raystar 125 to the block. The green should be attached to the red not to the yellow. Am I correct that the diagram is incorrect?

Chris