[CA] [CA11] 0.0ft reading
|
01-07-20, 11:54 AM
(This post was last modified: 01-07-20 04:06 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] 0.0ft reading
I have a c-series depthfinder. I recently put on a new airmar transducer and it was reading fine but after I had a wire burned on my horn it hasn't operated correctly. Now the unit reads 0.0ft, the same thing as before I replaced the transducer. I am going to replace my main ground wire from centerconsole to battery because I do not think it is any good. My Question is:
Is it possible that I may have a bad power connection/ground connection that may make my unit not read right even though it comes on with no problem. Or do I have to buy another transducer AGAIN. Any help is appreciated, thanks in advance |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] 0.0ft reading - boudreaux77450 - 01-07-20 11:54 AM
RE: [CA11] 0.0ft reading - Chuck - Raymarine - Moderator - 01-07-20, 04:14 PM
|
User(s) browsing this thread: 1 Guest(s)