The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] i40 BiData depth
01-19-20, 06:26 PM (This post was last modified: 01-22-20 10:00 AM by Chuck - Raymarine - Moderator.)
Post: #1
[CA11] i40 BiData depth
My newer 140 Depth signal keep counting down from normal depth to 00 after a few minutes and stays at 00. Today my speed also says 00. The both use to work fine. Is it a seatalk problem? The i40 is using my old autohelm Depth & speed transducer. The old autohelm with seatalk work fine but the old screen was badly cracked. The on & off switch on the board is fine. Any ideas? Thanks
PS Trying to see if there are any old wire connections in the lines that might be shorting...
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA11] i40 BiData depth - jpmesa - 01-19-20 06:26 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)