[CA] [CA11] "No transducer connected."
|
02-24-20, 05:20 PM
Post: #4
|
|||
|
|||
RE: [CA11] "No transducer connected."
fidlerjim,
It was never intended that the specified reset be performed following every MFD software update. However, there were some issues associated with earlier software updates leaving behind remnants of corrupted settings. It is hoped that this should not be necessary with the introduction of the LH3 v3.12.x software update ... however, time will tell. Any software update to an Evolution autopilot should be followed by the actions specified within the FAQ found here. Should any odd behaviors be observed with a networked fishfinder sonar module, then a Sonar Reset should be commanded from within the menu of the Fishfinder application. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] "No transducer connected." - fidlerjim - 02-22-20, 02:26 PM
RE: [CA11] "No transducer connected." - Chuck - Raymarine - Moderator - 02-24-20, 01:34 PM
RE: [CA11] "No transducer connected." - fidlerjim - 02-24-20, 05:07 PM
RE: [CA11] "No transducer connected." - Chuck - Raymarine - Moderator - 02-24-20 05:20 PM
|
User(s) browsing this thread: 1 Guest(s)