The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Upgraded autopilot. No dockside wizard.

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Upgraded autopilot. No dockside wizard.
02-25-20, 02:08 AM (This post was last modified: 02-25-20 12:02 PM by Chuck - Raymarine - Moderator.)
Post: #1
Bfb1115 Offline
Junior Member
**
 		Posts: 10
Joined: May 2019
Reputation: 0
[CA11] Upgraded autopilot. No dockside wizard.
Hello! Just upgraded my old nav computer and autopilot head to ACU-400, EV1, and P70s. Still running an E-80 MFD. used the seatalkng converter, and all se to be hooked up properly. I’ve attempted to commission the new system, but the “commissioning” menu does not appear anywhere in calibration settings or elsewhere, despite how far I scroll down. I’ve factory reset the P70s. It is running software version 3.07. I will be updating the software for the rest of the devices this week. Will that allow the menu to appear?

I’ve run the self-diagnostic on the P70s->about system, and the only device that shows up is the P70s. Is this normal?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Upgraded autopilot. No dockside wizard. - Bfb1115 - 02-25-20 02:08 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication