The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Communications v / RAY60 with v1.28

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
RAY60 with v1.28
06-08-16, 04:28 PM (This post was last modified: 06-09-16 09:48 AM by Chuck - Raymarine - Moderator.)
Post: #1
psubill78 Offline
Junior Member
**
 		Posts: 14
Joined: May 2016
Reputation: 0
RAY60 with v1.28
I have a RAY60 with v1.28 (upgraded over the internet) - but I'm confused, I do not see v1.28 anywhere. I have a 2nd station that is new out of box with VH1.01 on it. When I turn on the 2nd station - I get a complete blank screen (I can see power).

I downloaded the v1.24 on a card, and told the a12 to check the card for upgrades, and it says there are none (probably because the radio is at a newer version that on the card).

I attempted to upgrade the handset to v1.04 as shown here : http://www.raymarine.com/view/?id=13240 however that doesn't seem to work either.

Never see the 2nd handset show up on the a12 display or the RAY60 settings. Unit exhibits same behavior with 2nd station mic plugged directly into the ray60, as well as through the extension cable I purchased.

Thoughts? Suggestions?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RAY60 with v1.28 - psubill78 - 06-08-16 04:28 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication