Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Type II Hydraulic Arm Hose Question
05-05-20, 01:12 AM
Post: #2
RE: Type II Hydraulic Arm Hose Question
Hello Phil,

The short answer is that if you had loose fittings then that would be apparent from a fluid leak, but just to confirm: the fitting into the linear itself and the hex barrels (as in, used to tighten the fittings) should not move, but it's ok for the elbows to rotate as this allows the system to adapt to movement of the drive in use and for different installation locations.

Does this answer the question?

Regards,
Tom

Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Type II Hydraulic Arm Hose Question - Tom - Raymarine - Moderator - 05-05-20 01:12 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)