Raymarine forum / Raymarine Forums / General Discussions v / [TG] interfacing VHF/Vessel View SC5000/ Axiom 9 /RS150 ant

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[TG] interfacing VHF/Vessel View SC5000/ Axiom 9 /RS150 ant
05-07-20, 10:12 PM
Post: #2
Tom - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,067
Joined: Nov 2017
Reputation: 7
RE: [TG] interfacing VHF/Vessel View SC5000/ Axiom 9 /RS150 ant
Hello Robert,

If the ICOM VHF is 0183-only then our STNG-NMEA0183 interface is probably suitable, but I would suggest checking 2 things on the VHF:
  1. Our interface only outputs GLL messages, no other NMEA0183 data
  2. Our interface is not an isolated output, so the input of the VHF must or you risk a ground loop (not a good thing)

On the VesselView display: Mercury's SmartCraft is proprietary data, but if you use one of the SmartCraft - NMEA2000 gateways that they offer then that may well allow the SC5000 to get your Axiom's GPS data and also should allow the Axiom to get the engine data, but I would suggest asking Mercury about that.

Regards,
Tom
Raymarine since 1999.
Interests: Diagnosis of problems in sonar/fishfinders, NMEA2000, ethernet comms, autopilots, thermal cameras
Location: Sydney, Australia.

Please don't PM me asking for direct support, please ask a public question instead so that others can see the question and answer. Forum posts will always be answered before PM requests.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [TG] interfacing VHF/Vessel View SC5000/ Axiom 9 /RS150 ant - Tom - Raymarine - Moderator - 05-07-20 10:12 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication