[JB] Trouble with SeaTalk connectors
|
05-11-20, 09:11 AM
(This post was last modified: 05-13-20 08:17 PM by Jules - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
Trouble with SeaTalk connectors
I am having a new problem with SeaTalk ng connectors. I have plugged/unplugged these connectors previously with no problems whatsoever, but in the process of installing a new system with some new/longer backbone cabling I have had a helluva time with unplugging newly installed cabling from my 5-way connectors and T-connectors. They install easily enough, and the system has even ops checked good, but when disconnecting those same connections they simply won't pull out no matter what. Perhaps I should carefully lubricate the small o-rings on the cable connector end before inserting? If so, wondering if there is a recommended lubricant or process? This is all I can figure to do. Thanks for any advice! A search of the internet for similar complaints came up with nothing...
David |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Trouble with SeaTalk connectors - tyed - 05-11-20 09:11 AM
RE: Trouble with SeaTalk connectors - Jules - Raymarine - Moderator - 05-13-20, 08:30 PM
|
User(s) browsing this thread: 1 Guest(s)