[TG] [TG11] Wind transducer wind angle issue

[TKP62]

Tom,

The i60 is on STNG with the transducer wired to the iTC-5. I can try the reset and re-linearize but not sure how to reset if doing through iTC-5.

I’m not sure how steady the needle turns when rotating the vane feather. I was up the mast rotating it while a helper was below reading and selecting the calibration settings through the i70 menus.

If I can do a reset, I’ll re-linearize by motoring in circles where I can directly observe the displays. Is it possible that trying to linearize by manually rotating the feather, and maybe not doing it smoothly, that I actually introduced error into the process which is causing the angle error?

Thanks,
Tim