[TG11] st6001 auto operates clutch but "no comp"

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[TG] [TG11] st6001 auto operates clutch but "no comp"

05-23-20, 12:05 AM (This post was last modified: 05-27-20 01:33 AM by Tom - Raymarine - Moderator.)

Post: #1

sailalibi2.0 Offline

Junior Member

Posts: 1
Joined: May 2020
Reputation: 0

[TG11] st6001 auto operates clutch but "no comp"

auto button from both control head and wireless remote fails to move the rudder but the clutch operates and locks the wheel. The display says "no comp". The rudder reference sensor measures out ok as does the type 1 ram. The course comp fails to put voltage out on the motor leads but when I disconnect the motor leads and apply voltage the ram moves the rudder fine. Also the head unit shows no rudder bar (the option is on). This failure started over night. Is the head unit bad or the computer?

« Next Oldest | Next Newest »

Messages In This Thread

[TG11] st6001 auto operates clutch but "no comp" - sailalibi2.0 - 05-23-20 12:05 AM

RE: [TG11] st6001 auto operates clutch but "no comp" - Tom - Raymarine - Moderator - 05-27-20, 01:37 AM

User(s) browsing this thread: 1 Guest(s)