[TG] [TG11] Replacing st-50 wind with st-60
|
06-15-20, 08:02 AM
Post: #3
|
|||
|
|||
RE: [TG11] Replacing st-50 wind with st-60
I am not sure if this applies here but can a NMEA Micro-c connector be installed on the wind transducer cable to facilitate connecting and disconnecting the wire each time the mast is removed for storage??? Also would this interface directly with a NMEA 2000 system that is connected through a seatalk converter to the ST60 wind and the other seatalk instruments as well as the NMEA 2000 data?
Mainly trying to simplify the wiring in the boat but will use a Micro-c to connect the wires to ease mast removal if not connecting through NMEA 2000. Ken |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[TG11] Replacing st-50 wind with st-60 - ritsim - 06-02-20, 08:23 AM
RE: [TG11] Replacing st-50 wind with st-60 - Tom - Raymarine - Moderator - 06-11-20, 01:25 AM
RE: [TG11] Replacing st-50 wind with st-60 - Arcflash - 06-15-20 08:02 AM
RE: [TG11] Replacing st-50 wind with st-60 - Tom - Raymarine - Moderator - 06-16-20, 09:21 PM
|
User(s) browsing this thread: 1 Guest(s)