Connecting Raypilot 65 into Seatalk circuit

[Chuck - Raymarine - Moderator]

Welcome to the Raymarine Forum Lew,

Unfortunately, this long retired autopilot device is no longer supported and as such the support concerning this product is limited to the information found with the corresponding product documents posted on Raymarine's web site ... unfortunately, the Raypilot 65 is not among the listed documents. Based on what we can recall, coupled with your experience, the Raypilot 65 appears that it was designed to be installed as a SeaTalk device.

SeaTalk instruments, autopilot components, GPS sensors, and chartplotters featuring a 1st generation SeaTalk interface which do not additionally feature a SeaTalkng interface (ex. ST40/60 Instrument Displays, ST6001, S2G, Wireless AP Controller, Raystar 125 GPS Sensor, etc.) should be interfaced to one another, in any order, using standard SeaTalk Cables. SeaTalk Cables can be joined using D244 SeaTalk Junction Blocks, splices, marine grade terminal strips, or R55006 SeaTalk Auxiliary Junction Boxes. SeaTalk Cable is available in 15", 1m, 3m, 5m, and 9m lengths. This method of interfacing is referred to as a SeaTalk bus.

Over the years, Raymarine offered products with SeaTalk communications interfaces accepting SeaTalk cables having bare leads, round 3-pin plugs twist-locking plugs, and flat 3-pin press-fit plug (used within the latest products featuring a SeaTalk communications interface). SeaTalk communications networking products and adapters may be found here.

http://www.raymarine.com/view/?id=5535