ST6001 Calibration
|
06-24-16, 08:16 AM
(This post was last modified: 06-24-16 08:40 AM by Chuck - Raymarine - Moderator.)
Post: #2
|
|||
|
|||
RE: ST6001 Calibration
Jefreg,
Should the autopilot not be able to complete the deviation circles when turning at no more than the maximum specified rate of turn, then it is recommended that the compass be tested per the FAQ found here. Should the autopilot compass be found to meet the values specified within the FAQ, then it would normally be recommended that the autopilot course computer be sent to Raymarine's Product Repair Center to be bench tested / serviced. However, since Raymarine can no longer service the S2/S2G autopilot course computers, it would now be suggested that it be replaced with an EV200 Power/Sail Autopilot. |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
ST6001 Calibration - Jefreg - 06-23-16, 10:11 PM
RE: ST6001 Calibration - Chuck - Raymarine - Moderator - 06-24-16 08:16 AM
RE: ST6001 Calibration - Jefreg - 06-28-16, 11:19 AM
RE: ST6001 Calibration - Chuck - Raymarine - Moderator - 06-29-16, 11:12 AM
|
User(s) browsing this thread: 1 Guest(s)