[CA] [CA11] E28081 Wind Transducer Service Kit Instructions

[Chuck - Raymarine - Moderator]

Joe,

The wind transducer shown within your photo is the early transducer offered for the ST60 Wind Instruments. As with the wind transducers produced for currently manufactured Raymarine instruments, the wind transducer's vane shaft of later versions of these transducers was round and featured flat surface to properly align the vane when it onto onto the transducer's vane shaft. Very early versions of transducers designed for ST60 Wind Instruments featured shafts lacking the specified alignment flat on the shaft. As the replacement vane kits now come exclusively with a matching flat surface inside of the vane's shaft [censored], it may necessary to modify the vane opening to accommodate pressing the vane onto the completely round shaft of these early transducers. After installing the vane, the Wind Instrument should be calibrated. Is the wind transducer still interfaced directly to a ST60 Wind instrument? If so, its owner's manual (includes calibration information) may be found herehere.