Removing antenna from open array
|
09-04-16, 01:40 PM
(This post was last modified: 09-12-16 10:04 AM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: Removing antenna from open array
Chuck,
I have the same issue, except that I have been unable to even take the 2007 analog radar off the hard top, and can't enjoy my new one. It appears that unless I can remove the antenna arm, I cannot access the screws that attach the pedestal to the SeaView radar and TV mount. So, like Bill, after removing washer and nuts, I can't lift the arm off the pedestal. Getting these 4 screws loose has become an unsuccessful obsession. I have soaked with 6-56 etc, but it looks like they are fused to the support, and gentle hammering with a rubber mallet has not produced the desired result. What's the next less gentle method (physical or chemical), also considering that I don't have a lot of space to work with up there? Any help or advice welcome! |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
Removing antenna from open array - bstreep - 07-16-16, 01:06 AM
RE: Removing antenna from open array - Chuck - Raymarine - Moderator - 07-19-16, 03:36 PM
RE: Removing antenna from open array - Mountain Boy at Sea - 09-04-16 01:40 PM
RE: Removing antenna from open array - Chuck - Raymarine - Moderator - 09-12-16, 11:03 AM
|
User(s) browsing this thread: 1 Guest(s)