The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
ST60 Tridata in repeater mode
08-10-16, 10:02 PM
Post: #1
ST60 Tridata in repeater mode
I have two ST60 Tridata displays connected with seatalk cables (also with Wind and autopilot). Speed and Depth transducers are connected to one, and the other is in repeater mode. Everything basically works fine, except ...

- I am able to calibrate the temperature (and other readings) on the master without problem.

- I cannot calibrate the temperature on the Repeater (nor other readings).

- I cannot change the Speed mode to "yes" on the repeater (perhaps not a surprise as no transducer is connected).

My problem is that the temperature display on the repeater is ~5 degrees different from the master. I suspect that the unit I am using as a repeater (I bought it used) has some previous calibration settings for temperature that I cannot change unless it is directly connected to a transducer.

Is this true? Is there anything I can do to allow me to have the temperatures match?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
ST60 Tridata in repeater mode - walmsleyc - 08-10-16 10:02 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)