The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
TackTick wireless wind transmitter not transmitting
09-25-16, 03:55 PM
Post: #1
TackTick wireless wind transmitter not transmitting
I have a TackTick wireless wind transmitter and MN30 display that came with my boat when I purchased it a year ago. Both have worked flawlessly until the recent tropical storm passed the west coast of Florida a couple of weeks ago. I first noticed a problem when after the storm passed we went sailing and I noticed the anemometer had ceased spinning and the display was showing no wind direction and speed as dashes. Assuming that the bearings needed replacing, I went up the mast and retrieved the transmitter. Since I had it down, I opted to replace the battery also. After replacing the battery and the bearing kit I tried in vain to re-pair the transmitter with the display as outlined in the manual with no success. I set the unit out in bright sunlight to charge the battery in case it might not be fully charged and tried again, with no success. Is there any way to test the transmitter to determine if it is actually transmitting? It has always been a reliable unit and I hate to replace it if I don't need to.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
TackTick wireless wind transmitter not transmitting - sharkwatcher - 09-25-16 03:55 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)