Threaded Mode | Linear Mode

BosSH

Chuck,
Thanks very much for your detailed reply. I gather from your reply that all of the NMEA 0183 data interfaced to the master MFD will be shared with the repeater MFD via the ethernet cable. I do have an additional question based upon your response: you noted that 10hz is required for the MARPA interface to the MFD's from the course computer, and that 10hz is available on the S2G and S3G course computers. I have the S2 autopilot course computer; not S2G (i.e., without the built in gyro). The Smart Pilot Installation Guide for my system gives a 10hz 0.1 degree resolution from NMEA 1 port for the S1 and S2 course computers. Will the NMEA 1 port on my S2 course computer be an appropriate source of heading sensor data for the MFD's?

Please note that I mistakenly sent you another message that repeated some of the questions that you have already answered; please disregard that message.

Thanks again.
BosSH