Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
i40 display defaults
01-06-17, 09:31 AM (This post was last modified: 01-06-17 09:33 AM by Chuck - Raymarine - Moderator.)
Post: #2
RE: i40 display defaults
Welcome to the Raymarine Forum timo_collins,

The i40 and ST40 Instruments are each designed to sense both speed (through water) and water temperature when interfaced to a compatible instrument transducer. The design of these instruments is such that if water temperature is not sensed by the transducer (ex. transducer's water temperature leads not connect to corresponding instrument terminals; problem with the water temperature transducer (click here to view FAQ including resistance table), or there is a fault with the instrument's temperature sensing circuity), then the i40 and ST40 Instruments will revert to being a speed Repeater rather than a speed Master. This will also cause the instrument to report --- for speed rather than 0.0 when the vessel is stationary and not exposed to current.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
i40 display defaults - timo_collins - 01-05-17, 07:36 PM
RE: i40 display defaults - Chuck - Raymarine - Moderator - 01-06-17 09:31 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)