CAM 200IP cabling

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

CAM 200IP cabling

06-23-16, 02:13 PM (This post was last modified: 06-23-16 02:15 PM by Chuck - Raymarine - Moderator.)

Post: #9

Chuck - Raymarine - Moderator Offline

Administrator

Posts: 14,319
Joined: Oct 2014
Reputation: 43

RE: CAM 200IP cabling

george123,

One of the differences between Raymarine's SeaTalkhs Patch Cables and Raymarine's RJ45 to RJ45 Patch Cables is that only wire pairs 1&2 and 3&6 are used in a SeaTalkhs Patch Cable to support Ethernet communications only. Wire pairs 4&5 as well as 7&8 are additionally required when powering over Ethernet. It is correspondingly recommended that the SeaTalkhs Patch Cable be replaced with an appropriate length of Raymarine's RJ45 to RJ45 Patch Cable. Raymarine recommends POEs rated at 48VDC x .35A.

« Next Oldest | Next Newest »

Messages In This Thread

CAM 200IP cabling - Pdog1989 - 03-03-16, 01:39 PM

RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 03-03-16, 01:55 PM

RE: CAM 200IP cabling - Pdog1989 - 03-03-16, 01:58 PM

RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 03-03-16, 02:41 PM

RE: CAM 200IP cabling - george123 - 06-22-16, 06:24 PM

RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16, 07:47 AM

RE: CAM 200IP cabling - george123 - 06-23-16, 09:19 AM

RE: CAM 200IP cabling - george123 - 06-23-16, 02:12 PM

RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16 02:13 PM

RE: CAM 200IP cabling - george123 - 06-23-16, 04:04 PM

RE: CAM 200IP cabling - Chuck - Raymarine - Moderator - 06-23-16, 04:12 PM

User(s) browsing this thread: 1 Guest(s)