Tacktick wind malfunction

[Peluchi]

Chuck,
I am doing follow up on this thread as I seem to be having a very similar issue. I purchased a new T101 system along with a Microtalk to interface with my SeaTalkng (specifically an EV1 autopilot) 3 weeks ago. I installed the Microtalk and tested it along with the T112 display and the T120 transducer, in the locations I wanted to mount them. The exception would be the T120 was not at the top of the mast but I did place it approximately 30' (9 meters) away. Everything worked excellently, with T112 receiving and P70 control head for EV1 receiving the wind data.
I then installed the T120 at the top of the mast and.......nothing works! No information being received at the T112 nor on the Seatalkng via the Microtalk. I have checked the Health option for the Wind Transmitter Signal Strength but only --- shown. No signal strength I believe....
My mast and boom are aluminum, sails are dacron, height of mast is 46' (14 meters). I had the T101 parts fully charged before install and then left them in full sun for 3 days before retesting the system again.
I cannot believe I would have to send these parts in for service as they are brand new and worked straight out of the box 2 days before installing the transducer on the mast!

Please advise...

Regards,
Rodney