Wheel drive bulkhead mount bracket

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

Wheel drive bulkhead mount bracket

11-15-17, 04:04 PM (This post was last modified: 11-15-17 04:19 PM by Chuck - Raymarine - Moderator.)

Post: #5

randytank Offline

Junior Member

Posts: 13
Joined: Jul 2017
Reputation: 0

RE: Wheel drive bulkhead mount bracket

Because the bulkhead where the wheel is on my new boat has a pronounced knuckle in it I need to lay out the wheel drive carefully so I don't have to drill the relief [censored] for the drive motor into the knuckle. I want to make a template to do this. I may have to rotate the unit so the [censored] will be in the flat of the console. Can you give me either a CAD drawing of the attached drawing or give me the angles "P" and "Q" ?
Can I use the location "C" as an alternate for the pin on the drive bracket?

« Next Oldest | Next Newest »

Messages In This Thread

Wheel drive bulkhead mount bracket - mzorn - 04-13-17, 06:39 AM

RE: Wheel drive bulkhead mount bracket - Chuck - Raymarine - Moderator - 04-14-17, 07:36 AM

RE: Wheel drive bulkhead mount bracket - randytank - 11-08-17, 01:24 PM

RE: Wheel drive bulkhead mount bracket - Chuck - Raymarine - Moderator - 11-08-17, 02:01 PM

RE: Wheel drive bulkhead mount bracket - randytank - 11-15-17 04:04 PM

RE: Wheel drive bulkhead mount bracket - Chuck - Raymarine - Moderator - 11-15-17, 04:51 PM

User(s) browsing this thread: 1 Guest(s)