The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.3.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Wheel drive bulkhead mount bracket
04-13-17, 06:39 AM (This post was last modified: 04-18-17 09:49 AM by Chuck - Raymarine - Moderator.)
Post: #1
Wheel drive bulkhead mount bracket
I am installing Evolution Wheel Drive on my sailing catamaran. This is a bulkhead mount. I have cut a 2" [censored] in the bulkhead for the drive motor to pass thru. My question is "Is the bracket that goes in slot 1 or slot 2 necessary?" On a pedastal mount, the drive motor would be in mid air and the pedastal bracket will hold the wheel assembly stationary. On my bulkhead mount, the [censored] for the drive motor would be doing the same job. Would eliminating the bracket place too much stress on the motor?

The boat is a sailing catamaran which weighs 8600 lbs.

Thank you.
Mark Zorn
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
Wheel drive bulkhead mount bracket - mzorn - 04-13-17 06:39 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)