Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Splice Quantum Data Cable
04-19-17, 02:31 PM
Post: #2
RE: Splice Quantum Data Cable
Welcome to the Raymarine Forum capecodboater,

Q1. Can I crimp a standard RJ45 connector to the end of the cable and then use the RayNet (F) to RJ45 (F) Adaptor (Part #A80247)
A1. It is indeed possible to crimp a RJ45 plug onto the cable's leads to support the adaptation which you have suggested. However, only shielded RJ45 plugs should be used.

Q2. If I crimp a RJ45 connector to the cable, do I use a typical CAT-5 B diagram?
A2. Please click here to view a FAQ identifying the type of termination to be used when installing the RJ45 plug.

Q3. Am I better off using a standard punch junction board to make the connection and then seal it?
A3. This approach would not be recommended as it may introduce noise within the Ethernet communications path.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Splice Quantum Data Cable - Chuck - Raymarine - Moderator - 04-19-17 02:31 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)