Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Standard horizon gx2200 connected to eS78
05-31-17, 10:29 AM
Post: #2
RE: Standard horizon gx2200 connected to eS78
Welcome to the Raymarine Forum Jepetof,

Please click here to view a FAQ addressing this subject, paying particular attention to the items addressing the system's Data Master MFD and configuration of the Chart application page/pane being viewed. Should the items within the referenced FAQ have been addressed and should the problem persist, then it is recommended that a NMEA 2000 Analyzer (ex. Actisense NGT-1 w/PC running Actisense NMEA Reader software, etc.) be interfaced to the SeaTalkng / NMEA 2000 backbone to inspect the backbone for PGNs containing AIS target data. More information concerning NMEA 2000 PGNs may be found here. Should these PGNs be observed, then it would be recommended that the NMEA 2000 data be logged for at least 10 minutes and that the log then be attached to this thread for further analysis. Please click here to view a FAQ addressing this subject.
Visit this user's website Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Standard horizon gx2200 connected to eS78 - Chuck - Raymarine - Moderator - 05-31-17 10:29 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)