The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error





Thread Closed 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Dock to Dock Autorouting is producing a two point route over land
06-30-17, 01:16 PM (This post was last modified: 09-18-17 01:35 PM by Chuck - Raymarine - Moderator.)
Post: #1
Dock to Dock Autorouting is producing a two point route over land
Dock to Dock Autorouting is producing a two point route over land

Please click here to view a related FAQ. Should the items specified within the referenced FAQ have been addressed within your system, then the reported symptom is typically results from failure of one or more of the automatic route generation constraints (i.e. a straight line drawn between the starting and ending waypoint) would be the result of failure of one or more of the following criteria:
• The system has failed to recognize that the Navionics chart card has an active Navionics Freshest Data subscription and/or has been updated with recent Navionics Freshest Data per the referenced FAQ. This failure condition may be verified by examining the MFD's Route menu to determine with it lists "Dock to Dock Autorouting". Should this exact label not appear, then the MFD's software has encountered this problem. While v19.03 corrects most such instances, it has also been reported within v19.03. This problem may be overcome by returning to the Home screen, ejecting the Navionics chart card via the My Data menu, re-inserting the Navionics chart card, and then returning to the Chart application.
• Automatic route generation can only be used when generating routes within the area covered by your compatible cartography. Routes are limited to 200 waypoints per route ... should the number of waypoints required to autoroute between the starting point and ending point exceed 200, then the reported symptom will occur.
• Automatic route generation can be used between waypoints less than 100 nm apart.
• Automatic route generation always uses the cartography’s minimum depth reading when calculating routes. Please refer to the Differences between automatic route generation functions section for further details.
• Automatic route generation will fail if the generated route will exceed the maximum waypoint or route capacity of the MFD.
• Automatic route generation will also fail if insufficient cartographic data is available.
• the route's starting point or ending point do not satisfy the minimum depth, width, and height constraints which have been specified for the boat details configuration settings
• the feature was unable to create a route satisfying the minimum depth, width, and height constraints which have been specified for the boat details configuration settings

When getting accustomed to the Dock to Dock Autorouting feature, it is recommended that customer's practice using the feature in deeper water before attempting create routes in shallow waters.


RAYFAQ#
Find all posts by this user
Thread Closed 


Messages In This Thread
Dock to Dock Autorouting is producing a two point route over land - Chuck - Raymarine - Moderator - 06-30-17 01:16 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)