Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] ST6001 Calibration Issues

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] ST6001 Calibration Issues
11-16-17, 05:36 PM (This post was last modified: 05-24-19 07:39 AM by Chuck - Raymarine - Moderator.)
Post: #8
Chuck - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 14,319
Joined: Oct 2014
Reputation: 43
RE: [CA11] ST6001 Calibration Issues
tpburt,

Q1. So if I disconnect, just follow the calibration procedure for the non-gyro units?
A1. Yes.

A2. Is it possible to just replace the course computer, and if so, what model would I need to go to?
A2. Unfortunately, it is not possible to do as you have suggested. Raymarine's currently manufactured autopilot is not compatible with the ST6xxx/ST7xxx/ST8xxx and ST70 Autopilot Control Heads. However, it the currently installed drive unit and rudder reference transducer are compatible with the Evolution Autopilots (to include a p70S/p70RS Autopilot Control Head, EV-1 CCU (performs course computer and heading sensor), and ACU-[censored] (model based upon the model of drive unit which is presently installed onboard the vessel).
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: ST6001 Calibration Issues - tpburt - 11-16-17, 03:18 PM
RE: [CA11] ST6001 Calibration Issues - Chuck - Raymarine - Moderator - 11-16-17 05:36 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication