The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Product Selection Assistance v / [CA] Axiom Pro RVX on PowerCat

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Axiom Pro RVX on PowerCat
12-06-17, 02:25 PM (This post was last modified: 12-08-17 11:58 AM by Chuck - Raymarine - Moderator.)
Post: #1
LarrySmith Offline
Junior Member
**
 		Posts: 4
Joined: Oct 2016
Reputation: 0
[CA] Axiom Pro RVX on PowerCat
I've just ordered a new Aquila 44 Power Catamaran (w Axiom Pro RVX), and trying to wrap my head around proper placement of the transducers. I've read the other threads regarding cats but they tend to deal with the previous product line.

1. Can I install transducers in each hull?
2. Will I see depth from each transducer?
3. The beam is 22' and location in engine area would probably place the transducers about 16-18' apart, are adjustments needed for the angle (0,12,20) to properly support RealVision 3D? I believe the installation location is zero degree, but will have to verify with manufacturer.
4. Any special cables or adapters required?
5. Is there any noteworthy discussion on the merits of plastic versus bronze?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA] Axiom Pro RVX on PowerCat - LarrySmith - 12-06-17 02:25 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication