E125 Touch not Responding

[N1ml]

I fired up the e125 today and went to the alignment procedure for a try based on a post in the forum. It failed the first test and went onto a fine test. All 25 touch points worked perfect. It then went to more points for a final align. At that point it passed but I think I may have not pressed something at the end. I did notice my batteries were low, 10.7 volts, due to a tripped home type panel breaker. I reset it and got the batteries recharged. I did the whole aligment again and all seems to work fine. I updated the firmware to 19.03 and all appears to work ok. Could the low battery voltage have caused a problem? I am doing all this on a boat lift with a tripple battery float charger, no engines running.