MyBB Internal: One or more warnings occured. Please contact your administrator for assistance.
[CA] Wiring for EC 200 autohelm

Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] Wiring for EC 200 autohelm
02-20-18, 10:12 AM (This post was last modified: 02-20-18 02:37 PM by Chuck - Raymarine - Moderator.)
Post: #1
[CA] Wiring for EC 200 autohelm
I'm installing an EV 200 autopilot on a 35' sailboat. The P70s Pilot controller will be mounted on a pod above the wheel. Can I use the longer seatalk "Backbone" cable connected to the controller, run it down the binnacle to ACU underneath the deck. And when I connect the EV1 sensor, does it matter which ends of the "T" connector goes where?
The way the instructions read, I need to connect a series of the shorter white seatalk cables with the 5 way connectors.

But all the cables should be interchangeable with the connectors and it should make no difference which port on the connector goes where. Correct??
Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
[CA] Wiring for EC 200 autohelm - davidbrownBat06 - 02-20-18 10:12 AM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)