The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [DG] S3G as backup of SPX-SOL

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] S3G as backup of SPX-SOL
04-09-18, 10:21 AM (This post was last modified: 04-09-18 10:36 AM by Chuck - Raymarine - Moderator.)
Post: #1
mm@maume.it Offline
Junior Member
**
 		Posts: 11
Joined: May 2017
Reputation: 0
[DG] S3G as backup of SPX-SOL
Hi all

after reading the thread "SPX-5 as backup to EV-200" 11-01-2017, I would like to use my old S3G as a standby backup of the SPX-SOL.

As I have only ST1 network, I'll use a diverter applied to "off switch" contacts of both autopilots to have only one at a time working.

I think it's possible connect the solenoid and clutch cables to the respective contacts of both autopilots, but I don't know if it's possible to have the rudder and fluxgate sensors cables permanently connected to the respective contacts of both autopilots.

So before risking damage, I look forward to knowing the opinion of the guru.

All the best
Maurizio
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG] S3G as backup of SPX-SOL - mm@maume.it - 04-09-18 10:21 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication