[CA] e127 not recognizing radar

[Chuck - Raymarine - Moderator]

Tony,

Q. Is there a way to check the cable ??
A. I have noted that you have verified power through the cable. Please refer to the FAQ referenced within my initial response. The referenced FAQ included a link addressing how the Ethernet communications path may be tested from the radome to the RayNet plug which may be plugged into either of the MFD's Ethernet Network sockets. After removing the cover of the radome, you will find the Ethernet cable (terminated with a RJ45 (M) plug) which may be connected to the Ethernet tester being used. As specified within the referenced FAQ, should the loaded system power supplied to the radome be within the power specification for the radome and should the Ethernet communications path be verified, then it would be recommended that the radome be sent to Raymarine’s Product Repair Center to be bench checked / serviced.