[CA] [CA11] Quantum 2 to Axiom

[GreggCT]

After replacing the digital radome with the Quantum 2 on Sunday the new radome won't "power on". The radar is attached via an A80308 cable through an HS5 switch to an Axiom 9RV and Axiom 7. Neither Axiom can "find" the radome. The lights on the HS5 flash for the 2 Axioms but not for the connector where the radar is attached. I tried interfacing via the network and disconnecting the network cable and trying via WIFI. The radar just appears to not power on. BTW I did check and I have voltage at the end of the original cable but I did not check to make sure the A80308 had continuity. Also the digital I removed was working fine.

Anything else I should check before I contact service?

Thanks!