Post Reply 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA11] RS150 STNG connection failure
06-13-18, 09:53 PM (This post was last modified: 06-14-18 08:29 AM by Chuck - Raymarine - Moderator.)
Post: #5
RE: [CA11] RS150 STNG connection failure
STng bus has termination plugs each end. (I think drawing shows extra concentric circle).

Third party (Vesper) AIS firmware updated last week.

I did see some message about NOT manually selecting some data sources (either those NOT STng or NEMA 2000/Cannet)

Batteries are fully charged with winter charger (we launch tomorrow); no such thing as shore power after that.

I find it odd that the Master Axiom sees the RayStar 150 when it is connected at the either end of the STng backbone, but not in the middle.

My legacy TriData, Wind, Close Hauled and Multi are all ST50+. The ST600 and ST1 NEMA0183 converter I am not sure of their classification.

Find all posts by this user
Quote this message in a reply
Post Reply 

Messages In This Thread
RE: [CA11] RS150 STNG connection failure - edwardkern - 06-13-18 09:53 PM

Forum Jump:

User(s) browsing this thread: 1 Guest(s)