The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Updating/replacing older Control head/Computer

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Updating/replacing older Control head/Computer
06-05-18, 09:47 AM (This post was last modified: 06-07-18 10:27 AM by Chuck - Raymarine - Moderator.)
Post: #1
mbjezior Offline
Junior Member
**
 		Posts: 5
Joined: Feb 2018
Reputation: 0
[CA11] Updating/replacing older Control head/Computer
Setup question...replaced outdated electronics on my Carver 370 Aft Cabin- (38’). New Vulcan 7FS plotter will not interact with old autopilot- Raypilot 650 - all it detects is the rudder deflection position. The raypilot system is seatalk 1, which I converted via a digital yacht converter to 0183, then converted to 2000 via an actisense NGW-1 (4800 baud). Really not sure why it won’t communicate....my only option I believe is to replace the raypilot 650 and computer....will this system work- Raymarine EV-150 Power Pilot Core Pack? I have a type 1 drive unit already installed from the old system- (worked great and probably could save me dollars if I can still use it)..
Any suggestions are greatly appreciated!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Updating/replacing older Control head/Computer - mbjezior - 06-05-18 09:47 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication