The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / General Discussions v / [DG] [DG11] Autohelm navcenter

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Autohelm navcenter
06-07-18, 03:38 AM (This post was last modified: 06-07-18 11:24 AM by Derek - Raymarine - Moderator.)
Post: #1
davmori Offline
Junior Member
**
 		Posts: 1
Joined: Jun 2018
Reputation: 0
[DG11] Autohelm navcenter
Help please i have bought a boat with very old autohelm1991 navcentre...
i can not get the navcentre cursor to flash or give lat long or gps st 50 to give a lat /long..
the black box transponder reads 5 volt output to autohelm antenna.
the nmea 0183 output cable i have has only 2 cables out but. has about 5/6 pins currently it is attached the gps st50? which reads. no data!

can i attach it direct to the navcentre?.. should be attached to the seatalk plug on navcentre which currently has nothing attached.. ?
can i feed a nmea 0183 out of my standard horizon300 plotter to the input of the navcentre or gps (seatalk)
i just like to use the C maps in the navcentre with reference to my position which i have many
im sure there are lots of you can help me please!
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[DG11] Autohelm navcenter - davmori - 06-07-18 03:38 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication