[CA11] DSM360 Problems

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] DSM360 Problems

07-11-18, 03:39 PM

Post: #7

seeray96 Offline

Junior Member

Posts: 46
Joined: Jun 2016
Reputation: 0

RE: [CA11] DSM360 Problems

Chuck -

Thanks for all the info. It turns out that the xducer cable had a bend or partial coil withe less than 6 in radius - much less, in fact, and it was just a few inches from the connector. I kept jiggling the cable area close to the connector, and finally got the green led! I'm going to figure a way to fix the cable exactly in the current position.

I'm convinced the radius requirement is VERY important!

Thanks again.

Ray C.

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] DSM360 Problems - seeray96 - 06-18-18, 12:12 PM

RE: [CA11] DSM360 Problems - Chuck - Raymarine - Moderator - 06-19-18, 12:21 PM

RE: [CA11] DSM360 Problems - seeray96 - 06-25-18, 12:19 PM

RE: [CA11] DSM360 Problems - Chuck - Raymarine - Moderator - 06-25-18, 02:34 PM

RE: [CA11] DSM360 Problems - seeray96 - 07-05-18, 03:48 PM

RE: [CA11] DSM360 Problems - Chuck - Raymarine - Moderator - 07-06-18, 08:53 AM

RE: [CA11] DSM360 Problems - seeray96 - 07-11-18 03:39 PM

RE: [CA11] DSM360 Problems - Chuck - Raymarine - Moderator - 07-12-18, 04:45 AM

User(s) browsing this thread: 1 Guest(s)