Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] System upgrade
06-26-18, 03:39 PM (This post was last modified: 06-26-18 03:42 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: [CA11] System upgrade
Welcome to the Raymarine Forum Rick,

General comments:

A powered and properly terminated SeaTalkng / NMEA 2000 backbone will be installed to permit each product featuring a SeaTalkng / NMEA 2000 communications interface (MFD, i70S, Evolution autopilot components, and AIS500) to be interfaced as an individual spur to the backbone. Following the software update specified below, the AIS500 may be interfaced as a spur to the backbone. The backbone will include a SeaTalk to SeaTalkng Converter to permit the ST60 instruments to be interfaced to the system. Before doing so, the ST60 instruments must be disconnected from their previous source of power.

It is not clear if/why a NMEA 0183 multiplexer would need or be desired within the list of equipment to be interfaced onboard.

Q1. After that can I ditch the existing Actisense NMEA0183 Data Multiplexor and a Raymarine NMEA0183 or should I connect the icom to the 0813 network and keep the Multiplexer's?
A1. The MMSI and static data of the AIS500 may be cleared by a Certified Raymarine Installer or by Raymarine’s Product Repair Center. The installer should be instructed to also update the AIS500 with the latest available software update to permit it be interfaced as a spur to the system's powered and properly terminated SeaTalkng / NMEA 2000 backbone.

Q2. How do I wire the VHF so DSC is functional?
A2. As the system features a Raystar 130 GPS Sensor, the MFD will not be the system's data source for GPS data. Accordingly, NMEA 0183 sentences transmitted via the MFD's NMEA 0183 leads will feature the $EC rather than $GP NMEA 0183 Talker ID. Unlike the overwhelming majority of marine communications products, ICOM communications products are designed to reject NMEA 0183 sentences featuring NMEA 0183 Talker IDs other than $GP. However, should a E70196 VHF NMEA 0183 to STng Converter Kit be added to the backbone and the NMEA 0183 input leads of the ICOM VHF radio be interfaced to it, then the ICOM VHF may receive NMEA 0183 GPS sentences featuring the $GP Talker ID from the VHF NMEA 0183 to STng Converter Kit.

Q3. is the external GPS receiver still necessary?
A3. Typically, external GPS receivers are installed where they will have an unobstructed view of the skies overhead, permitting them to receive greater GPS signal strength and thereby be more dependable than other GPS receivers onboard the vessel. Accordingly, it is recommended that the Raystar 130 GPS Sensor be interfaced a spur to the backbone and that the MFD's Data Sources feature be configured to manually select the Raystar 130 GPS Sensor as the system's data source for GPS, Date & Time, and Datum.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] System upgrade - rickgiles - 06-25-18, 01:53 PM
RE: [CA11] System upgrade - Chuck - Raymarine - Moderator - 06-26-18 03:39 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)