Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Smartpilot S2 to seatalkNG
07-17-18, 01:33 PM
Post: #2
RE: [CA11] Smartpilot S2 to seatalkNG
Welcome to the Raymarine Forum Godind,

The p70/p70S/p70R/p70RS autopilot control heads feature communications circuitry which will support either SeaTalk or SeaTalkng communications, but not both simultaneously. When interfaced to a S1/S2/S3/S1G/S2G/S3G autopilot course computer, a p70/p70S/p70R/p70RS autopilot control head must be installed as a SeaTalk device rather than a SeaTalkng Device. In the case of a S1/S2/S3/S1G/S2G/S3G autopilot course computer, these course computers feature two SeaTalk ports. It is recommended that one of these SeaTalk ports be interfaced to a D244 SeaTalk Junction Block via an appropriate length of SeaTalk Cable. This same D244 SeaTalk Junction Block would then be interfaced to the p70/p70S/p70R/p70RS autopilot control head via an A06073 / 39.4in (1.0m) SeaTalk to SeaTalkng Adapter Cable (supports only SeaTalk communications). It is recommended that second of these SeaTalk ports be interfaced to a second D244 SeaTalk Junction Block via an appropriate length of SeaTalk Cable. This same D244 SeaTalk Junction Block would then be interfaced to the SeaTalk socket of a SeaTalk to SeaTalkng Converter using the cable supplied with the SeaTalk to SeaTalkng Converter Kit. It is recommended that the SeaTalk to SeaTalkng Converter be updated with the latest available Raymarine product software update. As you have indicated the SeaTalk bus which which will be connected to the SeaTalk to SeaTalkng Converter will not be powered (disconnect the red lead of the SeaTalk Cable connecting its bus to the course computer's SeaTalk port.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [CA11] Smartpilot S2 to seatalkNG - Chuck - Raymarine - Moderator - 07-17-18 01:33 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)