[CA] [CA11] Yamaha to Axiom Pro
|
09-29-18, 01:23 PM
(This post was last modified: 09-30-18 04:06 AM by Chuck - Raymarine - Moderator.)
Post: #3
|
|||
|
|||
RE: [CA11] Yamaha to Axiom Pro
Thanks,
Assuming I get the networking sorted out I would link to use a small Ray MFD to replace the current gauges. I was thinking a basic Axiom 7. Is it possible to configure this or a different model mfd to start upon sensing voltage vs. having to slide the power on each time? I would like to power the unit from the ignition switch. Thanks |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Yamaha to Axiom Pro - scott06903 - 09-17-18, 08:56 PM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 09-18-18, 10:21 AM
RE: [CA11] Yamaha to Axiom Pro - scott06903 - 09-29-18 01:23 PM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 09-30-18, 04:09 AM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 10-10-18, 08:29 AM
RE: [CA11] Yamaha to Axiom Pro - scott06903 - 10-14-18, 07:11 AM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 10-15-18, 10:21 AM
RE: [CA11] Yamaha to Axiom Pro - scott06903 - 10-16-18, 11:55 AM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 10-16-18, 12:26 PM
RE: [CA11] Yamaha to Axiom Pro - scott06903 - 10-17-18, 08:14 AM
RE: [CA11] Yamaha to Axiom Pro - Chuck - Raymarine - Moderator - 10-17-18, 10:15 AM
|
User(s) browsing this thread: 1 Guest(s)