Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Evolution EV-100 Wheel pilot system
04-27-16, 03:10 PM (This post was last modified: 04-27-16 03:12 PM by Chuck - Raymarine - Moderator.)
Post: #2
RE: Evolution EV-100 Wheel pilot system
jefndeb,

First, let me comment on the diagram of your initial system. At most, each SeaTalk to SeaTalkng Converter is designed to support a SeaTalk bus containing up to five SeaTalk devices. You original system featured a SeaTalk bus of seven devices. This bus should have been divided into two smaller SeaTalk busses and each bus would have then been interfaced to a SeaTalk to SeaTalkng Converter which had been updated with v1.21 (now v2.01) or later SeaTalk to SeaTalkng Converter software. The two SeaTalk to SeaTalkng Converters would then have been joined to one another via an appropriate length of SeaTalkng Backbone Cable. Only one SeaTalkng Power Cable would have been installed to power the SeaTalkng backbone created by these two SeaTalk to SeaTalkng Converter.

The SeaTalkng backbone specified above may be extended to the SeaTalkng 5-Way Connector supplied with the Evolution autopilot using an appropriate length of SeaTalkng Backbone Cable to connect the backbone socket of the SeaTalkng 5-Way Connector to one of the SeaTalkng backbone sockets of either of the SeaTalk to SeaTalkng Converters.
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: Evolution EV-100 Wheel pilot system - Chuck - Raymarine - Moderator - 04-27-16 03:10 PM

Forum Jump:


User(s) browsing this thread: 2 Guest(s)