The following warnings occurred:
Warning [2] count(): Parameter must be an array or an object that implements Countable - Line: 802 - File: showthread.php PHP 7.4.33 (Linux)
File Line Function
/showthread.php 802 errorHandler->error




Raymarine forum / Raymarine Forums / Autopilots v / [CA] [CA11] Ev150 to N2K for “other” MFD to work

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[CA] [CA11] Ev150 to N2K for “other” MFD to work
01-24-19, 09:27 PM (This post was last modified: 01-25-19 08:49 AM by Chuck - Raymarine - Moderator.)
Post: #1
sr330da Offline
Junior Member
**
 		Posts: 9
Joined: Sep 2018
Reputation: 0
[CA11] Ev150 to N2K for “other” MFD to work
On my boat I’ve installed a EV150, Ray53, and Axium 9. Very happy. All’s good.

My friend just purchased a EV150 and we just installed it in his boat. Unfortunately, his MFD is a Lowrance HDS gen3. Prior to the install, we installed his components on my MFD and updated them in the correct order.

We have the EV150 system attached to the NEMA2000 port on his MFD with a Seatalk to NEMA2000 cable.

The HDS sees all the Ray autopilot components and is receiving data on 2 of the 3 Ray autopilot components. I noticed the P70rs doesn’t have a address associated with it like the other components do. Just says 0. But it has a Instance number like the other two components.

The HDS sees the P70rs on the device listing but when I push “autopilots” non are available. We updated his MFD software and it even told us the Ray softwares were up to date.

Any ideas?
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
[CA11] Ev150 to N2K for “other” MFD to work - sr330da - 01-24-19 09:27 PM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication