[CA] [CA11] Interfacing older S2 Autopilot computer to new SeaTalkNG Network
|
02-05-19, 11:56 AM
(This post was last modified: 02-05-19 03:50 PM by Chuck - Raymarine - Moderator.)
Post: #1
|
|||
|
|||
[CA11] Interfacing older S2 Autopilot computer to new SeaTalkNG Network
Morning all,
I am beginning to plan out the network for a suite of new electronics on a 40ft sailing sloop. Every piece of equipment with the exception of the older autopilot will be replaced. I am planning to have the axiom pro 9 MFD at the heart, fully networked with a proper SeaTalkNG network to all other devices. The current Autopilot course computer is the S2. The current control head being used with it is the ST6000. Can I plug the S2 course computer into the new SeaTalkNG network (on a 5 way connector) via the SeaTalk1 to SeaTalkNG converter kit with the yellow plug, and be able to use the P70s to control the autopilot? Or should I use the d244 and A22164 route to connect directly to the P70s? In addition, once the new autopilot control head is installed, do I need to then recalibrate the autopilot? |
|||
« Next Oldest | Next Newest »
|
Messages In This Thread |
[CA11] Interfacing older S2 Autopilot computer to new SeaTalkNG Network - tralavoi - 02-05-19 11:56 AM
|
User(s) browsing this thread: 1 Guest(s)