[CA] [CA11] RV-200 transducer with Axiom Pro

[Chuck - Raymarine - Moderator]

Pete,

You have followed all of the correct steps to this point. The reported issue is often overcome with Axiom RV MFDs by:
- switching the MFD OFF
- disconnecting the transducer(s) from the MFD by unplugging from the transducer cable(s) from the MFD's TRANSDUCER socket
- switching the MFD ON
- commanding the MFD to perform a Factory Reset
- upon completion of the Factory Reset, switch the MFD OFF
- wait 30 seconds
- plug the transducer(s) into the MFD's TRANSDUCER socket
- switch the MFD ON.

Once corrected, the procedure specified above should not need to be repeated in the future.

Should the problem persist, and no modifications or splices were made to the transducer's cable, then it would indicated a problem with the MFD's fishfinder circuitry or with the transducer itself. This issue would typically be fault isolated by interfacing the MFD to a RV-100 transducer. Should the MFD have been installed by a Certified Raymarine Installer, then it would be recommended that the installer be contacted to perform this test. If not, it would be recommended that the MFD sent to Raymarine’s Product Repair Center to be bench checked / serviced.