Raymarine forum / Raymarine Forums / Networking / System Integration v / [DG] [DG11] Adding an RMK10 to two axioms - switch not powering on

Post Reply 
 
Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
[DG] [DG11] Adding an RMK10 to two axioms - switch not powering on
03-06-19, 06:36 AM
Post: #8
Derek - Raymarine - Moderator Offline
Administrator
*******
 		Posts: 1,416
Joined: Nov 2017
Reputation: 9
RE: [DG11] Adding an RMK10 to two axioms - switch not powering on
Hi Wstandis

there are two types of RJ45 Ethernet couplers used to join cables, one is a 'straight through' couple where all the pins connect pin for pin, the other is a 'crossover coupler' where the data pins are swapped or transposed. They are used in specific applications where the data appears to be interrupted or erratic, hence the suggestion to use the crossover coupler in this instance.
Thanks
Derek
Find all posts by this user
Quote this message in a reply
Post Reply 


Messages In This Thread
RE: [DG11] Adding an RMK10 to two axioms - switch not powering on - Derek - Raymarine - Moderator - 03-06-19 06:36 AM

Forum Jump:


User(s) browsing this thread: 1 Guest(s)

Contact Us | Raymarine forum | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication