[CA11] Verifying NMEA cable function

Thread Rating:

0 Vote(s) - 0 Average
1
2
3
4
5

Threaded Mode | Linear Mode

[CA] [CA11] Verifying NMEA cable function - AIS not communicating

03-20-19, 07:30 PM (This post was last modified: 03-21-19 12:34 PM by Chuck - Raymarine - Moderator.)

Post: #5

andyschoenb Offline

Junior Member

Posts: 14
Joined: Apr 2018
Reputation: 0

RE: [CA11] Verifying NMEA cable function - AIS not communicating

Hello Chuck
Quick update - I ran the wrap around test and there was not receive signal. So I pulled the wire at the helm and low and behold it appears when the PO installed the wire and then screwed the NavPod to the Helm post - the screw cut through the White and Green wires so that the return path was cut. GO FIGURE. I am in the process of running a new NMEA 0183 wire and that should take care of it.
Again - I greatly appreciate your expertise and support'
Andy

« Next Oldest | Next Newest »

Messages In This Thread

[CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-17-19, 05:26 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-19-19, 02:00 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-19-19, 06:38 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-20-19, 07:45 AM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-20-19 07:30 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-21-19, 12:34 PM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - andyschoenb - 03-22-19, 06:25 AM

RE: [CA11] Verifying NMEA cable function - AIS not communicating - Chuck - Raymarine - Moderator - 03-25-19, 10:12 AM

User(s) browsing this thread: 1 Guest(s)